Steel vs Plastic Landscape Edging: Which One Should You Buy?
Steel and plastic landscape edging compared on material, height, length, stakes and install, with two examples of each side from the listings we reviewed.

On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
MIXC 100ft Landscape Edging Kit with 150 Spikes, 3-Pack9.7/10View on Amazon - 2
STIRLINGEAR 33ft Cor-Ten Steel Landscape Edging, 10-Pack9.6/10View on Amazon - 3
STIRLINGEAR 20ft Cor-Ten Steel Landscape Edging, 6-Pack9.6/10View on Amazon - 4
JERIA 4 Inch Tall 66 FT Garden Edging Kit with 90 Spikes9.6/10View on Amazon
Verdict: Choose steel for a hammer-in border with a rust patina finish. Choose plastic for a no-dig install, with the MIXC kit giving the longest run per pack here.
A bed edge that stays put starts with the ground it sits in: flat lawn, sloped beds and paths that curve around trees. The steel vs plastic landscape edging question comes down to what the border must do. The steel kits here hammer in and weather to a rust patina, and their strips bend for curves as well as straight lines. The plastic kits go in without digging, and the MIXC kit states use on slopes.
AcreMowerLab earns a commission when you shop through links here. It never changes your price. Affiliate disclosure.
The four examples

MIXC 100ft Landscape Edging Kit with 150 Spikes, 3-Pack
Three 33 ft rolls of HDPE edging, 1.5 inches tall, with 150 spikes.
Who it's for: owners with long, curving runs or slopes who want a no-dig install.
Who should skip it: owners who want a tall border.
The maker lists three 33 ft rolls of HDPE edging for 100 ft total, 1.5 inches tall, with 150 spikes and pre-drilled holes for a no-dig install. The HDPE resists UV damage, extreme temperatures and pressure, with 3 to 5 years of reliable use stated. The L-dual-layer design blocks soil erosion and root intrusion, and the pack weighs 2.0 lb.
Pros
- 100 ft total is the longest run here
- 150 spikes is the most fasteners here
- HDPE resists UV damage for 3 to 5 years stated
- Dual-layer design blocks soil erosion and root intrusion
Cons
- 1.5-inch height is the lowest here
- Suits soft land, and hard ground does not take the spikes well
- Three rolls must be laid end to end for the full 100 ft
- Comes in black only

STIRLINGEAR 33ft Cor-Ten Steel Landscape Edging, 10-Pack
Ten 40-inch Cor-Ten steel strips with 11 stakes, 5 inches tall.
Who it's for: owners who want a low steel border with a rust finish along beds and paths.
Who should skip it: owners who want a taller border or a no-dig install.
The maker lists ten 40-inch Cor-Ten steel strips for 33 ft of edging, with 11 heavy-duty stakes and a total height of 5 inches, including 3-inch stakes that go underground so 2 inches show above ground. The strips bend for straight lines or curves, and the steel forms a rust patina with no painting stated. The pack weighs 17.0 lb.
Pros
- Cor-Ten steel forms a rust patina with no painting stated
- 11 heavy-duty stakes anchor the 10 strips
- Bends for straight lines or curves
- 2 inches show above ground for a low border
Cons
- No warranty term is stated
- Only 2 inches show above ground
- Hammer-in install needs a hammer
- Rust patina forms over time

STIRLINGEAR 20ft Cor-Ten Steel Landscape Edging, 6-Pack
Six 40-inch Cor-Ten steel strips, 8 inches tall, with 6 stakes.
Who it's for: owners who want an 8-inch steel border with clean, gap-free lines.
Who should skip it: owners who want the longest run per pack.
The maker lists six 40-inch Cor-Ten steel strips for 20 ft of edging, 8 inches tall, with 6 stakes and a seamless connection system that leaves no gaps between pieces. The connectors fasten with a rubber mallet, and the strips bend along curves and bed edges. The pack weighs 17.0 lb.
Pros
- 8-inch height is the tallest here
- Seamless connection system leaves no gaps between pieces
- Cor-Ten steel forms a rust finish over time
- Flexible strips bend along curves and bed edges
Cons
- No warranty term is stated
- 20 ft total is the briefest run here
- Hammer-in install needs a rubber mallet for the connectors
- Rust finish forms over time

JERIA 4 Inch Tall 66 FT Garden Edging Kit with 90 Spikes
A 66 ft roll of plastic edging, 4 inches tall, with 90 spikes.
Who it's for: owners who want one long plastic roll with a 4-inch border and no digging.
Who should skip it: owners who want the longest run or the most spikes.
The maker lists one 66 ft roll of plastic edging, 4 inches tall, with 90 spikes for a no-dig install. The border trims to round, square, heart or arc shapes, and it helps prevent weed growth along gardens, pathways and lawns. The roll weighs 15.0 lb, and the hammer is not included.
Pros
- 66 ft in one roll covers long runs
- 4-inch height shows a clear border
- Trims to round, square, heart or arc shapes
- No digging needed for install
Cons
- Hammer is not included
- 90 spikes is fewer than the 150 in the MIXC kit
- 4-inch height is shorter than the 8-inch steel kit
- 15.0 lb roll to carry and unroll
Other machines to compare
WORTH Garden Black Galvanized Steel Landscape Lawn EdgingCheck price on Amazon
20ftCheck price on Amazon
VEVOR Galvanized Steel Landscape EdgingCheck price on Amazon
VEVOR Steel Landscape EdgingCheck price on Amazon
VEVOR Steel Landscape Edging 40 x 6 in 6 Packs Metal GardenCheck price on Amazon
Edge RightCheck price on Amazon
Steel vs plastic landscape edging side by side
| Factor | STIRLINGEAR 33ft Steel | STIRLINGEAR 20ft Steel | MIXC 100ft Plastic | JERIA 66ft Plastic |
|---|---|---|---|---|
| Length | 33 ft, 10 strips | 20 ft, 6 strips | 100 ft, 3 rolls | 66 ft, 1 roll |
| Height | 5 in, 2 in above ground | 8 in | 1.5 in | 4 in |
| Stakes or spikes | 11 stakes | 6 stakes | 150 spikes | 90 spikes |
| Material | Cor-Ten steel | Cor-Ten steel | HDPE plastic | Plastic |
| Install | Hammer-in | Hammer-in, rubber mallet | No digging | No digging |
| Weight | 17.0 lb | 17.0 lb | 2.0 lb | 15.0 lb |
| Best at | Beds, walkways, patios | Pathways, raised beds | Slopes, farms, parks, pathways | Gardens, pathways, lawns |
Figures are manufacturer stated for the four example models, collected 20 November 2026.
Material: Cor-Ten steel or HDPE plastic
Both steel kits use Cor-Ten weathering steel, which forms a rust patina over time with no painting stated. The MIXC kit uses high-density polyethylene, which resists UV damage, extreme temperatures and pressure, with 3 to 5 years of reliable use stated. The JERIA kit states plastic material.
Height and how much shows
The 20 ft steel kit has an 8-inch total height, the tallest figure here, while the 33 ft steel kit has a 5-inch total height with 2 inches showing above ground. The JERIA plastic roll is 4 inches tall, and the MIXC plastic kit is 1.5 inches tall, the lowest figure here. Only the 33 ft steel kit states how much shows above ground once installed.
Length, stakes and coverage
The MIXC kit covers the longest run at 100 ft in three 33 ft rolls with 150 spikes, and the JERIA kit covers 66 ft in one roll with 90 spikes. The steel kits cover shorter runs: 33 ft in ten 40-inch strips with 11 stakes, and 20 ft in six 40-inch strips with 6 stakes. Count the run you need before you order.
Install: hammer-in or no digging
The steel kits hammer in: the 33 ft kit drives 3-inch stakes underground, and the 20 ft kit fastens its connectors with a rubber mallet. The plastic kits need no digging: the MIXC kit uses pre-drilled holes and spikes, and the JERIA kit sets spikes straight into the ground. The MIXC kit suits relatively soft land, and hard ground does not take its spikes well.
What each side handles
The steel kits define grass, flower beds, walkways and patios, and outline pathways and raised beds, and both state flexible strips that bend for curves. The plastic kits state curve and slope uses: the MIXC kit bends around uneven terrain and states a dual-layer design that blocks soil erosion and root intrusion on slopes, and the JERIA kit trims to round, square, heart or arc shapes.
Acreage and terrain fit
STIRLINGEAR 33ft Steel
STIRLINGEAR 20ft Steel
MIXC 100ft Plastic
JERIA 66ft Plastic
Matching It to Your Property
- Flat beds and straight runs: the two steel kits hammer in with stakes, and both state strips that also bend for curves.
- Curves and slopes: the MIXC kit bends around curves and states slope use with a root blocker.
- Soft ground: the MIXC kit suits relatively soft land, and hard ground does not take its spikes well.
The Acre Score explained
The Acre Score weighs performance (length, height and what it covers), build (material, stakes and spikes), value (what comes in the box), safety (certifications the listing states) and warranty (years and coverage). A factor the listing does not state scores zero, so all four score zero for safety and warranty.
| Product | Acre Score | Perf. /35 | Build /25 | Value /25 | Safety /10 | Warranty /5 |
|---|---|---|---|---|---|---|
| MIXC 100ft Plastic | 9.7 | 32 | 21 | 22 | n/a | 0 |
| STIRLINGEAR 33ft Steel | 9.6 | 30 | 21 | 21 | n/a | 0 |
| STIRLINGEAR 20ft Steel | 9.6 | 29 | 21 | 20 | n/a | 0 |
| JERIA 66ft Plastic | 9.6 | 28 | 20 | 20 | n/a | 0 |
Acre Scores are spread from 9.2 up to 9.8, and each weighted total takes its place on that spread proportionally, so the mower with more points is always shown above the one with fewer. Powered machines get safety points, as do listings that name safety features; manual items are scored out of 90.
The listings differ by kit, so match the height, length and install type of each example to the run you have.
Read the manual, keep children and pets out of the yard while you work, wear eye and hearing protection and sturdy footwear, and never exceed the slope rating of your machine. Refuel only with the engine off and cool. See CPSC lawn mower safety. Read our Safety Disclaimer.
FAQ: mowing large lots
Does steel landscape edging rust?
Yes, by design. Both steel kits use Cor-Ten steel, which forms a rust patina over time: the 33 ft kit states a stable rust-like patina with no painting, and the 20 ft kit states a natural rust finish.
Do I need to dig to install plastic edging?
No. The MIXC kit states no ground excavation is required, with pre-drilled holes and spikes. The JERIA kit states you do not need to dig: insert the spikes into the ground and fasten the border.
How tall is the edging once it is installed?
The 33 ft steel kit states 2 inches showing above ground from its 5-inch total height. The other kits state total heights only: 8 inches for the 20 ft steel kit, 4 inches for the JERIA plastic roll and 1.5 inches for the MIXC plastic kit, with no above-ground figure stated.
Which side suits slopes?
The MIXC plastic kit states it suits slopes and rainy climates, with a dual-layer design that blocks soil erosion and root intrusion. The steel kits state hammer-in stakes and flexible shaping, but neither states slope use.




