Lawn Roller Parts and Replacements
Lawn roller parts, from drain plugs to deck wheels and roller pins, wear at the seal, the bore and the bolt, so match size and part number before ordering.

On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
Brinly 485 lb. Tow Behind Poly Lawn Roller with Easy Turn Plug9.8/10View on Amazon - 2
VEVOR Tow Behind Lawn Roller9.7/10View on Amazon - 3
VEVOR Lawn Roller 13 Gallon Large Capacity Sand/Water Filled9.7/10View on Amazon
When a roller stops holding water, a deck wheel rattles across the lawn, or the deck starts to scalp on dips it used to clear, check the small parts before ordering a whole new roller. Lawn roller parts are the pieces that wear on the roller and the mower that pulls it: the drain plug that seals the drum, the deck wheels and anti-scalp rollers that keep the deck off the ground, the roller pins that hold the deck rollers, and the wheel assemblies that carry the mower. This guide names each part, shows what to measure, and explains how to match a replacement to the roller or mower already on the property.
AcreMowerLab earns a commission when you shop through links here. It never changes your price. Affiliate disclosure.
Lawn roller parts: the pieces that wear out
The parts below cover most replacements on a roller and the mower that pulls it. Each one is matched by size or part number, not by brand alone. If the roller itself is worn past repair, see the best lawn roller picks first, then come back for the part.
| Part | What it does | Match by |
|---|---|---|
| Drain plug | Seals the fill opening so water stays in the drum | Opening size and roller model |
| Deck wheel | Keeps the deck off the ground on dips and turns | Diameter, bore and width |
| Anti-scalp roller | Rolls under the deck edge to stop scalping | Outside diameter, width and bore |
| Roller pin | Holds the deck roller on its mount | Length, width and height |
| Wheel assembly | Carries the mower across the lawn | Diameter and part number |
| Mow ball | Supports a wheeled trimmer head | Outside diameter and bore |
Match the drain plug first
Start with the drain plug, because a plug that no longer seals lets the drum lose water during a pass. The listings name a 1-1/4 inch plug for Agri-Fab steel tow lawn rollers made in 2005 and later, including models 45-02163, 45-02164, 45-01798, 45-0549, 45-02168, 45-0610, 45-0604 and 45-0606. The plug is stainless steel and rubber, and the snap handle twists to open, then flips down to lock the plug in place.
One listing gives the plug as a 2-pack and measures the replacement at 3.88 inches tall overall, with a 1.36 inch handle width, a 1.32 inch plug body height, a 1.16 inch plug body width and a 0.90 inch ring opening. Match the opening size first, then check the model list. See the guide to lawn roller plug size for the fill cap and replacement plugs, and the guide to lawn roller weight for how a full drum behaves on the lawn.
Deck wheels and anti-scalp rollers
Deck wheels and anti-scalp rollers keep the mower deck off the ground when the ground dips or the mower turns. The listings give several sizes, so measure the wheel already on the deck before ordering. One 2-pack lists a 5 inch diameter, a 5/8 inch bore, a 2.67 inch height, a 2-1/2 inch hub and a 4.2 inch bolt, with polypropylene wheels and steel bolts, bushings and lock nuts, a weight of 3.0 pounds and a 1 year warranty from the maker. It fits Exmark and Kubota BX decks and Toro 60 inch and 72 inch decks.
A 4-pack lists a 5 inch height, a 2-3/8 inch width and a 1/2 inch bore, and fits 42, 46, 48, 50 and 54 inch decks, with a 2 year guarantee. A John Deere replacement lists a 4.9 inch outside diameter, a 1.9 inch height and a 0.67 inch bore in a 2-pack. A Kubota deck roller lists a 1/2 inch inside diameter, a 3 inch outside diameter and a 4 inch width, with 30 days money back and an 18 month warranty. The bore, the width and the outside diameter all have to match, because a wheel with the right diameter and the wrong bore will not sit on the bolt. See the mower deck wheel picks for the kits that fit common decks.
Roller pins, wheel assemblies and mow balls
A deck roller is only as good as the pin that holds it. One kit pairs a roller pin with a deck roller for Craftsman, MTD and Cub Cadet decks. The pin measures 7.85 inches long, 0.51 inches wide and 2.22 inches high, and the roller measures 5.98 inches long with a 0.59 inch inside diameter and a 2.36 inch outside diameter. The kit replaces part numbers 731-05679, 731-05679B and 711-3314A.
A Homelite wheel assembly (on Amazon) lists a 10 inch wheel under part number 330072007 for models RY401011 and RY401011VNM. A wheeled trimmer mow ball lists a 129 mm outside diameter, a 17 mm inside diameter and a 43.16 mm height in a 2-pack, and replaces part numbers 182217 and 532182217 on Husqvarna HU625WT and HU675HWT trimmers. A stainless steel conveyor roller lists a 15.75 inch roller length, a 17.32 inch total length, a 1.97 inch diameter and a 0.47 inch shaft, and fits 16 inch lawn mowers as a replacement for a plastic roller. Check the part number on the old part before ordering.
Check fit before you order
Match the part number on the old part or in the manual. Measure the bore, the outside diameter and the width with a tape or calipers, and compare each figure with the listing. Check the model list for the mower or roller, not just the brand, because one brand can use several sizes across its decks. Look at what is in the box, because some kits ship as a 2-pack with bolts, bushings and lock nuts, while others ship as a 4-pack of wheels with shoulder bolts and lock nuts.
Safety
Wear work gloves and disconnect the power before installing deck wheels. Keep children and pets out of the work area while the deck is raised or the roller is hitched. Work on flat, dry ground, and follow the manual for the mower or roller. A roller full of water is heavy to move, so drain the drum before lifting or storing it.
FAQ: mowing large lots
What parts does a lawn roller have?
A lawn roller has a drum, a drain plug, a hitch and a frame, and the mower that pulls it has deck wheels, rollers and pins of its own. The drain plug seal, the deck wheels and the roller pins are the parts to check first: the seal keeps water in the drum, while the wheels and pins take the load on every pass. Replacement plugs, wheels and pins are sold by size and part number, so match the old part before ordering.
How do I find the right drain plug size?
Measure the drain opening, then match the plug to the roller model. A 1-1/4 inch plug fits Agri-Fab steel tow lawn rollers made in 2005 and later, including models 45-02163, 45-02164, 45-01798, 45-0549, 45-02168, 45-0610, 45-0604 and 45-0606. The replacement is stainless steel and rubber with a snap handle that twists to open and flips down to lock.
How do I know which deck wheel fits my mower?
Match the diameter, the bore and the width, then check the part number and the deck size. A 5 inch wheel can carry a 5/8 inch bore or a 1/2 inch bore, and decks in the listings include 42, 46, 48, 50 and 54 inch sizes, so the diameter alone is not enough. Check the model list for the mower as well.
When should a deck roller be replaced?
Replace it when the roller wobbles on its pin, the surface is cracked or flat spotted, or the deck starts to scalp on dips it used to clear. Check the pin at the same time, because a pin that is bent or worn will wear the new roller out of round. Match the roller length, outside diameter and inside diameter to the old one.
What size roller fits a 16 inch mower?
A stainless steel roller listed for 16 inch mowers measures 15.75 inches long, 17.32 inches in total length and 1.97 inches in diameter, with a 0.47 inch shaft. Check the shaft diameter and the mounting holes before ordering, because the roller has to press into the same mounts as the plastic roller it replaces.
More mowing guides
- Best Lawn Roller (2026): 5 Top Picks Compared
- Lawn Roller Weight and How Heavy to Go
- Lawn Roller Plug Size: Fill Cap and Replacement Plugs
- Manual Lawn Roller: How to Choose and Use One
- Steel vs Plastic Lawn Roller: Which One Should You Buy?
- Best Mower Deck Wheels (2026): 5 Kits Compared
Use the Mower Matcher to narrow down choices by acreage, terrain, budget, and power type.




